Inergy Help

Venstar Thermostat Settings

Jon Lee

**Here are some steps to make sure your thermostat is set correctly: **

Venstar Thermostat Wifi Setup

Select Menu & arrow down to Wi-Fi & then select Set-up.

The thermostat will start “Scanning for Networks”.

A list of available WiFi networks will be displayed. Please click on your wireless network. NOTE: If the bars are yellow, then the signal is poor and will be an issue in connectivity.

The Setup screen will be displayed with the SSID name and the security type filled in. Click on the Password space.

The Enter Password screen will be displayed. Enter the passkey being careful to enter any numbers, lower and upper case letters correctly. Once the password has been entered, click “Done”.

Then click “Next.

Click “Next” again.

It will take up to 30 seconds for the thermostat to connect to the WiFi network.

Once it has connected, it will display “Success; Connection to (network name) established”. Click on “OK”.

On the WFii screen Click “Local API Options”. The Local API needs to be turned “ON”

On main Menu the SkyPort must be Off, as well as the weather under Skyport settings

Be sure local schedules are turned off.

Last Modified: 2 Years Ago
Last Modified By: jmaa
Level: Beginner
Rated 2 stars based on 2 votes.
Article has been viewed 529 times.
Also In This Category